in
All Tags » Cisco (RSS)

Browse by Tags

  • How to Configure mpls in GNS DYNAMIPS

    hello,i am doing lab on gns till now i have done routing part, with fram-relay. can i practice mpls also on gns. if yes than plz guide me how to configure gns for mpls, and plz send me some study material for mpls so that i can practice mpls also.
    Posted to Frame Relay (Forum) by network on 05-17-2010

  • How to Configure EIGRP STUB

    i want to have deep knowledge of EIGRP STUB. i have attached the scenario plz guide me in EIGRP STUB
    Posted to Frame Relay (Forum) by network on 05-12-2010

  • Frame Relay Hub n Spoke

    i am doing frame relay in GNS, not able to configure this toplogy.
    Posted to Frame Relay (Forum) by network on 04-23-2010

  • WHAT IS NAT

    plz explain me NAT in detail a - What is NAT, use of NAT b - What is Static NAT c - What is Dynamic NAT
    Posted to Frame Relay (Forum) by network on 04-22-2010

  • Hardware requiremnt for dynamips

    i want to study ccnp by my own, i had attended bootcamp for CCIE R/S but it was not at all useful as that was for only 30 days. what i came to know that through dynamips v can practice all labs. 1- Can i practice Internetwork-Experts Labs in dynamips 2 - Does dynamips supports frame-relay and mpls 3...
    Posted to Frame Relay (Forum) by network on 04-11-2010

  • Multicast Flooding

    I have a Video encoder that is streaming video to our external network. This encoder is connected to the same switch (SW1) as the router (sending the stream out). The encoder is on VLAN 10 and streaming works ok. I was checking the router interfaces and i found that the sub interface F0/1.10 (Video streaming...
    Posted to Frame Relay (Forum) by network on 03-26-2010

  • Cisco Aironet AIR-AP521G

    Backstory, Previous network support provider installed 3 of these Cisco access points (model: AIR-AP521G-A-K9). I take over the network and it is my responsibility to change the WPA keys quarterly. I have never used such a difficult or confusing solution for managing wireless. So two of the devices are...
    Posted to WAP (Forum) by network on 03-13-2010

  • Cisco 1721 ADSL Config problems

    Hello. I'm trying to setup a Cisco 1721 router with IOS 12.2(15)T8 with a ADSL wIC card. I've setup the configuration but cannot get it running, can someone please have a look at the config and see if they can tell me where they think the problem could lie? I've setup a cheap little D-Link...
    Posted to Misc (Forum) by network on 03-13-2010

  • Cisco PIX and no nat

    Hello, I have configured a pix 501 and everything works OK when I have nat configured to use a translated address on the outside interface (ie - I can ping hosts on the outside network from the internal network. However, I don't want to use nat - I don't want the inside addresses translated....
    Posted to Misc (Forum) by network on 03-13-2010

  • Cisco 4402 WLC configuration: Unable to control APs on other subnets

    I have a Cisco 4402 WLC at our main office. A WLAN has been configured and seems to be working properly as I can view the APs here at the main office. I also have 5 branch offices that I need to control APs at. What configuration do I need to add to the WLC to do this? My APs are model Cisco 1131G.
    Posted to WLAN (Forum) by network on 03-12-2010
Page 1 of 155 (1545 items) 1 2 3 4 5 Next > ... Last ยป